Bray 6A Series Quick Start Manuel d'utilisateur

RCONTROLSSeries 6A Quick Start GuideThis document is not comprehensive, it is intended to help fi rst time users become familiar with the Bray S6A Elec

Positioner OptimizationStep 21: Scroll to the Tight Open parameter (#41)Step 22: Decrease value to 90.Exit configuration mode by holding down the left

Mounting and Set-upStep 1: Place the mounting bracket on the rear side of the positioner. Tighten the mounting bolts and lock washers.Step 2: Positio

Mounting and Set-upStep 5: Mount the positioner on the actuator and tighten the mounting screws.Step 6: Insert the pneumatic fittings on the positioner

CalibrationStep 1: Power on the unit with a 4 to 20 mA signal.Step 2: Press the button below the ‘ ‘ symbol for >5 seconds to enter i

CalibrationStep 5: Press the ‘ ‘ to parameter 2. Select ‘90°’.Step 6: Scroll to parameter 4 by pressing the ‘ ‘ button.Step 7: Hol

CalibrationAdjust the wheel so that the numeric value in the top right hand corner of the display is below 6.If it is difficult to turn the wheel, confi

CalibrationStep 9: Acknowledge that the calibration was successful by pressing the ‘ ‘ button once and returning to the configuration mode. Exi

CalibrationStep 13: With the device in ‘AUTO’ mode, test the responsiveness of the device by varying the command signal from 4 mA to 20 mA.Step 14: Up

Positioner OptimizationStep 17: ContinuedStep 18: Scroll to the ‘Tight Closing with Manipulated Variable’ parameter – YCLS, #39 and select ‘uP do’ by